Descargar Imprimir esta página

VELECO GRAVIS Manual De Instrucciones página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

BASIC STEERING WHEEL CONTROLS
LEFT SIDE CONTROLS
High
/
Pass
beam switch – this
switch allows turning
ON / OFF high beam
lights. Pressing a Pass
doesn't lock the switch
in place, but allows
sending a short blink
of high beam light.
Left brake lever –
pulling
this
towards the direction
of the rider activates
the rear scooter brake.
FAILURE TO USE THE TURN SIGNALS PROPERLY MAY CAUSE OTHER TRAFFIC
PARTICIPANTS TO MISJUDGE USER INTENTIONS. ALWAYS COMMUNICATE YOUR
THE MANOEUVRE IS COMPLETED.
RIGHT SIDE CONTROLS
Headlight switch – used to
switch between low beam
/ position lights / turning
OFF main headlight beam.
READY button – used
to turn on / off the
acceleration throttle.
8
EN
Turn signal switch – the switch should be used to communicate
to other members of traffic the desire to turn or change lanes.
Pushing the switch left and right activates the respective turn
light
signal lights. It is possible to activate both indicators at the same
time, making them work as hazard lights. To turn off the signal,
push the button located in the middle of the switch.
lever
Riding mode switch – depending
on the position the switch is on,
when the acceleration throttle
is used the scooter will advance
either forward (D for forward) or
backwards (R for reverse).
Right brake lever – pulling this
lever towards the direction of
the rider activates the front
scooter brake.
Gear switch – the vehicle comes with three speed modes.
When the switch is in position:
(I) - the maximum speed of the scooter is limited to 1-6 km/h
(1-4 mph).
(II) - the maximum speed of the scooter is limited to 1-12 km/h
(1-8 mph).
(III) - the maximum speed of the scooter is limited to 1-12 km/h
(1-8 mph).
Parking brake – using
the
parking
brake
prevents
the
vehicle
from rolling back or
forward when parked
on uneven terrain (see:
Parking).
Horn button – pressing
the button activates
the horn.
caution
!
Acceleration throttle
– the throttle is used
to adjust the speed of
travel. By turning the grip
towards the rider, the
vehicle will gain speed.
Releasing
the
throttle
will cause the vehicle to
decelerate.

Publicidad

loading