ATON DLATP Manual Del Usuario página 10

DLATP Touch Pad Controller
2. Wiring/Installation
Wiring for the DLATP consists of a single run of Cat-5
wire between the DLA 2/4/6 speaker level audio
router IR Input and the IR Output of the DLATP at the
mounting location. If an external IR Receiver such as
ATON's AIR5 IR Receiver is to be used, run Cat-5 wire
from the mounting location of the IR Receiver to the
DLATP location.
Note: Do not run Cat-5 wires closer than 12"
from high voltage wires.
Note: Maximum wire run between the DLATP and
DLA 2/4/6 is 350'.
DLATP Rear
Cat-5
Figure 2.1: DLATP Pre-Wire
8
DLA 2/4/6
Room IR Input
©2008 • All rights reserved.