Publicidad
Idiomas disponibles
Idiomas disponibles
DLATP Touch Pad Controller
5. Troubleshooting
Symptom
Cause
DLATP does
1. Wiring installed
not power up
incorrectly; or wiring
pinout reversed
2. Break in Cat-5
between Zone and
"Head-End"
No control of
1. Wiring: Incorrect
IR sources
wiring between
DLATP and DLA
2/4/6
2. IR emitter defec-
tive at source
Intermittent IR
IR fl ooding
source control
No audio
1. Loose speaker
wires or bad
connection
20
Solution
Verify wiring pinout .
Correct by re-wiring
fl iplock connectors to
Cat-5 cable.
Check end to end
connections with cable
tester or voltmeter.
Verify and correct wiring.
Replace IR emitter.
Check to see if ambient
light is shining on built
in IR receiver or in direct
line with plasma TV
noise. If the IR Indicator
is fl ashing when IR is not
being sent, IR fl ooding
is indicated. Disable the
built-in IR Receiver. Con-
sider use of an external
IR Receiver.
Check both ends of
speaker wires to ensure
proper connection.
©2008 • All rights reserved.
Publicidad
