Publicidad
Idiomas disponibles
Idiomas disponibles
DLATP Touch Pad Controller
Installation
The DLATP is designed to mount in a standard single-
gang rough-in box (J Box). Typical mounting height is
56-60" from the fl oor to the bottom of the frame. This
provides optimum viewing for the largest number of
people.
Note: Do not mount the DLATP in the same
rough-in box as high voltage devices such as
electrical outlets or switches.
After running Cat-5, route the wires from the DLA
2/4/6 into the back of the rough-in box, then connect
them to the appropriate fl iplock connectors on the
rear of the DLATP. If using an IR Receiver, strip the
ends of three conductors of the Cat-5 from the IR
receiver and splice them onto the Cat-5 run back to
the DLA. Specifi c connections are detailed in Chapter
3. Connections.
Once connections are made, mount the DLATP into
the rough-in box using the 2 provided screws. Mount
the Trim Plate Bracket as shown in Figure 2.2, then
snap the Screwless Trim Plate in place.
Make sure that the arrows on both the Trim
Plate Bracket and the Trim Plate are pointed UP.
© 2008 • All rights reserved.
9
Publicidad
