ATON DLATP Manual Del Usuario página 12

DLATP Touch Pad Controller
Screw
Screw
DLATP
Screw
Screw
Figure 2.2: Installing the DLATP
Changing Overlay Film
The DLATP features available customized Graphic
Ovelay Films that can be changed to fi t the décor
of the room in which the touch pad is installed. See
Figure 2.3.
To change fi lms:
1. Remove the wall plate from the front of the
unit. Remove the two screws and wall plate
base. Unsnap and remove plastic frame.
2. Remove the two fi lm bracket screws on the top
frame of the unit.
3. Use the notch located in the upper right-hand
corner to open the touch screen (45° max.).
4. Remove the existing fi lm.
10
Rough-In
Stud
Box
Cat-5
©2008 • All rights reserved.