Publicidad
Idiomas disponibles
Idiomas disponibles
Gas cut-off safety assembly (for versions with thermocouple)
1. Push the gas range switch and turn anticlockwise to high flame position.
2. Ignite the lighter according to the version of your range.
3. After ignition, push and hold the switch for 3-5 seconds for activation of the safety
mechanism.
4. If no ignition occurs after pushing and releasing the switch, repeat the same action by
pushing and holding the switch for 15 seconds.
5. Set to the desired flame position.
6. When the cooking is completed, bring the switch clockwise to the upper point to switch
off.
Use of the gas oven
1-
Push the Gas Oven switch and turn 1-turn anticlockwise to high flame and-or
temperature position on the panel.
2-
If the oven button controls the burner of the upper heater, push the switch
and turn clockwise to the grill inscription or flame sign.
3-
Ignite the lighter according to the version of your oven.
a.
Open the oven door fully, press the gas oven knob and turn it
anticlockwise to the maximum temperature. The electric spark ignition
will be activated automatically. When the oven is lit, keep the knob
pressed down for a few seconds to allow the thermocouple to heat up.
If the burner does not ignite after 15 seconds, stop attempting to light it,
open the oven door completely and do not try to light it again for at
least 1 minute.
ALWAYS USE POTS WITHIN THE DIMENSION RANGE
INDICATED IN THE PREVIOUS DIAGRAM FOR EACH BURNER.
Size of the container and dimension of the gas flame should
comply with each other. Adjust the gas flame in such a way
that it will not protrude from the container base. Put the
container on the center of the pot carrier.
OFF
Electronic spark ignition (depending on model)
If the hob burners have a
thermocouple, the safety mechanism
is activated and cuts off the gas
immediately against turning off
resulting from liquid overflown.
Switch symbols on the control panel
indicate the corresponding function.
20
V.1
Publicidad
