Publicidad
Idiomas disponibles
Idiomas disponibles
3. 7 Tips for using your T-unit and OPTIMAL adjustment of the air intakes:
Once the unit has completed a first combustion cycle and it is hot enough, it is advisable to follow these
Recommendations to get the most out of your product.
Spread the embers from previous combustion cycles across the bottom of the burner.
It is preferable to use opened beech or similar wood with a humidity percentage of less than 20%.
Recommended fuel size
Mod. T 70:
one piece of wood between 30 and 45 centimeters in length and 1 to 1.6 kg weight.
Mod. T 80:
one piece of wood between 40 and 55 centimeters in length and 1.25 to 1,8 kg weight.
Mod. T 100:
one piece of wood between 45 and 65 centimeters in length and1.6 to 2 kg weight.
Adjust the primary air inlet to an opening of between 5 and 8 mm. For models T 60 and RK-60, close the
primary air regula on 100% of its range)
Adjust the secondary air inlet to halfway, i.e. at an angle of approximately 90º with the front of the device.
For models T 60 and RK-60, open the secondary air regula on lever 25% of its range)
To obtain stable and optimal performance and a clear view of the flames through the glass try to make
consecutive loads of wood with pieces as similar as possible, for that you must keep the same air inlet
regulation at any time.
4. MAINTENANCE
To clean the glass, be careful to spray the cleaning product on a cloth and clean only the glass, without
wetting the rest of the door. Window-cleaners and special products often contain chemicals that attack the
paint and the ceramic fiber seals and cause oxidation of the metal parts.
It is very important not to wet the wood burner with window-cleaner, water or special cleaning products.
Heatproof paint is not waterproof. Clean the paintwork with a feather duster or a soft, dry cloth. If over time
you want to repaint the insert, the manufacturer makes a spray paint available from your dealer.
5. TIPS, CHIMNEY SWEEPING AND SAFETY STANDARDS
You should check the chimney regularly and keep it clean and in good condition. Creosote build-up in the
chimney could cause it to catch fire.
Keeping the chimney conduct clean is of vital importance. The chimney should be cleaned periodically,
depending on the frequency of use and the type and humidity of the fuel used.
The maintenance of the appliance and the sweeping of the chimney should be done by a qualified
professional.
After a prolonged period of not using the device, check the chimney to make sure it is not blocked.
In case of chimney fire, immediately close the air inlets and use an extinguisher or call the fire
department.
The stove will become very hot when you light it. Don't touch the stove without protection during firing
and for two hours after.
Warn children of the danger of burns.
Children or the infirm are not allowed to use the stove.
Only retire the ashes when the stove is not working, and deposit them in a metallic container, there might
be burning embers among the ashes.
Do not modify the appliance without authorization and use only original spare parts.
There should be adequate supply of air to the space where the stove is installed, both for combustion and
convection air. The air grates should never be blocked.
23
Publicidad
