Parkside PASSK 20-Li B2 Traduccion Del Manual De Instrucciones Originales página 26

GB MT
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic fi eld which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we
recommend that persons with medi-
cal implants consult their doctor
and the manufacturer of their medi-
cal implant before operating the
machine.
Operation
Inserting/replacing the
tool
1. Push the desired bit (11-14) onto the
tool holder (1).
2. To remove it, pull the bit off from the
tool holder (1).
Set the direction of
rotation
You can toggle between right and left rota-
tion by pushing the direction of rotation
switch (5).
The direction changed may only be
performed in standstill mode!
1. Clockwise direction: Push the direction-
al switch (5) to the left up to the stop.
2. Counter-clockwise direction: Push the
directional switch (5) to the right up to
the stop.
26
Adjusting the torque
1. Press the torque button (7) briefl y once
to be able to read the current torque
on the display below.
2. Press the torque button (7) repeatedly
to adjust the set torque.
Inserting/removing the
rechargeable battery
1. To insert the batteries (8) into the de-
vice, push the batteries along the guide
rails into the device. You will hear them
click into place.
2. To remove the batteries (8) from the de-
vice, press the release button (8a) on
the batteries and pull the batteries out.
Charging the battery
If warm, allow the battery to cool
before charging.
Charge the battery (8) when only
the red LED on the battery charge
level indicator (8b) is illuminated.
1. If necessary, remove the battery (8)
from the machine.
2. Slide the battery (8) into the charging
slot of the charger (9).
3. Plug the charger (9) into a socket.
4. Once charging is complete, disconnect
the charger (9) from the mains supply.
5. Remove the battery (8) from the char-
ger (9).
Switching on/off
1. Press the on/off switch (3). The device
runs at the maximum speed.
2. To turn it off, release the on/off switch
(3).