To reassemble, please proceed as follows:
2.4
Operating the brakes
To apply the electromagnetic brakes:
1. Let go of the speed or drive lever, the electromagnetic brake in the motor will be activated, the
scooter will stop.
2.5
Transfer in and out the scooter
L
WARNING:
Risk of injuries – Always turn your scooter OFF before getting on or off your
scooter.
2.6
Correct position in the scooter
Some recommendations for a comfortable use of the scooter:
1. Position your backside as close as possible to the backrest.
2. Make sure your upper legs are horizontal.
•
Move the steering unit upwards.
•
Put the batteries back in and connect to
the battery plugs (plugs of the same color
go together).
•
Use the straps to tighten the batteries in
such a way that they will not move, even
during drives.
•
Mount the rear plastic cover.
•
Mount the seat (see "Adjusting the seat"
chapter).
To apply the parking brakes (optional):
1. Pull the brake lever towards the handgrip.
2. Release the brake lever .
The parking brake tightness can be adjusted by the
brake cable adjuster.
1. Park the scooter as close as possible to the place
where you want to transfer.
2. Check that the control panel (scooter) is switched
off.
3. Put the armpad on the side you want to transfer
upwards.
4. Transfer to / from the seat of the scooter.
Page 11
Ceres SE
2018-06