Operator Control; Neutral - Vermeiren Ceres SE Manual De Instrucciones

2.10 Operator control

•
Put the ON/OFF key switch on, please wait for at least 3 seconds before you press the speed
lever otherwise you have a "delay protection" alarm.
•
Now the battery level indicator
•
Now turn the speed switch
•
Pull the drive lever with your fingers backwards (right lever for forward movement, left lever for
backward movement).
•
To sound the horn, press the horn button
•
To put on the front and back lights, press the light button
•
To put on the emergency flashers, press button
•
To put on the indicator lights, press the desired button
indicator).
•
To stop the scooter loosen the speed lever under the operator control.
3
8
5
Vermeiren is responsible for the changes in the software. For changes in the software contact
Vermeiren.

2.11 Neutral

L
WARNING:
Control your scooter - Never put your scooter in neutral while you are
driving.
L
WARNING:
Control your scooter - Never put your scooter in neutral on slopes. It may
accidentally roll away.
L
WARNING:
Risk of injury - Never pick up the electronic drive before stopping the
motor/gears to prevent motor from overheating.
The scooter is fitted with a freewheel device that is accessible and operable by the attendant or the
user when not sitting in the scooter. You should only use the scooter in neutral to transport the scooter
or to move it out of a danger zone.
Put the scooter in neutral with the motor stop lever
•
Driving
1. Put the motor stop lever
2. Switch the ON/OFF key ON.
3. Electronically controlled driving is now possible.

will light up and shows the current level of your batteries.

to the desired driving speed.

.
1
2
7
4


on drive. This will again interlock the motor and gears.
Page 16

.

.
 
and (left = left indicator, right = right
6
1 = Trouble indicator
2 = Speed switch
3 = Head Lights
4 = Horn
5 = Indicator (left)
6 = Emergency lights
7 = Indicator (right)
8 = Battery level indicator
on the back side of the scooter.
Ceres SE
2018-06