Operating The Brakes; Transfer In And Out The Scooter; Correct Position In The Scooter - Vermeiren Mercurius 4 LTD Manual De Instrucciones

To reassemble, please proceed as follows:
•
Mount the rear plastic cover of the batteries.
•
Mount the seat (see "Adjusting the seat" chapter).
2.4

Operating the brakes

To apply the electromagnetic brakes:
1. Let go of the speed or drive lever, the electromagnetic brake in the motor will be activated, the
scooter will stop.
2.5

Transfer in and out the scooter

2.6

Correct position in the scooter

Some recommendations for a comfortable use of the scooter:
1. Position your backside as close as possible to the backrest.
2. Make sure your upper legs are horizontal.
•
Move the steering unit upwards.
•
Put the batteries back in and connect to
the battery plugs (plugs of the same color
go together).
•
Check that the cables are installed
properly and
together.
•
Use the straps to tighten the batteries in
such a way that they will not move, even
during drives.
To apply the manual brakes (optional) - emergency
braking:
1. Pull the brake lever towards the handgrip.
2. Release the brake lever.
To apply the manual brakes (optional) - parking
braking:
1. Pull the brake lever towards the handgrip and
use the button to lock it.
2. Squeeze the brake lever again to release the
button.
The manual brake tightness can be adjusted by the
brake cable adjuster.
1. Park the scooter as close as possible to the
place where you want to transfer.
2. Check that the control panel (scooter) is
switched off.
3. Put the armpad on the side you want to transfer
upwards.
4. Transfer to / from the seat of the scooter.
Page 11
Mercurius 4 LTD
2018-09
replace both batteries