Set Tds Factor - OHAUS 3100C Manual De Instrucciones

STARTER 3100C Bench Conductivity Meter
Use or
Press to confirm your setting. Continue with reference temperature setting by following
or press
Note:
If you set the temperature correction coefficient value as 0 %/° C , that means NO Temperature
Compensation for the conductivity measurement. The meter displays the real conductivity value
at current temperature.
3.5

Set TDS factor

After selecting the reference temperature, the current TDS factor blinks.
Use or
setting or press
buttons to adjust the temperature correction value. (0.00 to 10.00 %/° C).
to go back to the measurement screen.
buttons to adjust the TDS factor value. Press
to go back to the measurement screen.
EN-9
to confirm your