Hilti PD-E Manual Del Usuario página 14

5.4 Measuring using the spike
1. Fold out the spike through 90°. The spike can then be used as the
contact point.
Here, the spike helps to align the device while a stable position
is established. This is the case primarily for indirect, trapezoid
and Pythagoras measurements since these results are based on
estimated values.
Use the measuring extension PDA 72 for inaccessible places.
The device automatically detects the measuring extension.
confirmation window may appear in the display.
2. Fold out the spike through 180°. The measuring reference point is then
set automatically.
5.5 Measuring using a target plate
1. Use the target plate to measure distance under the following unfavorable
conditions:
▶ The wall is not sufficiently reflective due to the type of surface.
▶ The target point is not on a surface.
▶ The distance to be measured is very long.
▶ The light conditions are unfavorable (bright sunshine).
2. A distance of 1.2 mm should be added to the measured distance when
using a target plate.
5.6 Measurement mode
5.6.1 Single measurements
1. Press the "Measure" button briefly to activate the laser beam.
2. Keep the laser beam on the target point.
3. Press the "Measure" button briefly to take the measurement.
▶ The measured distance is shown in the lower line of the display.
▶ The distance measured in the previous measurement is shown in the
upper line of the display.
4. To take another measurement, keep the laser beam on the target point
and press the "Measure" button again.
5.6.2 Continuous measurement
During continuous measurement, 6-10 measurements are taken and
displayed every second. The laser range meter can be moved relative
to the target until the desired distance is reached.
1. Press the "Measure" button for 2 seconds.
▶ If the signal tone is active, a signal tone will be emitted.
10 English
3
4
2068470
*2068470*
A