Publicidad
Introduction for buttons on remote controller
Note:
● This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.
● After putting through the power, the air conditioner will give out a sound.
Operation indictor "
conditioner by using remote controller.
● Under on status, pressing the button on the remote controller, the signal icon "
on the display of remote controller will blink once and the air conditioner will give
out a "de" sound, which means the signal has been sent to the air conditioner.
● Under off status, set temperature and clock icon will be displayed on the display
of remote controller (If timer on, timer off and light functions are set, the corre-
sponding icons will be displayed on the display of remote controller at the same
time); Under on status, the display will show the corresponding set function icons.
1
On/Off button
Press this button to turn on the unit. Press this button again to turn off the unit.
2
Mode button
Each time you press this button,a mode is selected in a sequence that goes from
AUTO, COOL, DRY, FAN, and HEAT *, as the following:
AUTO
COOL
DRY
3
Fan button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, to
, then back to Auto.
4
▲ /
button
Press
▲
/
button to increase/decreaseset temperature. In AUTO mode,
set temperature is not adjustable.
When setting Timer On or Timer Off, press "▲" or "
5
Swing button
Press this button to set up & down swing angle.
6
Sleep button
Under Cool, Heat or Dry mode, press this button to turn on Sleep function.
Press this button again to cancel Sleep function. Under Fan and Auto modes, this
function is unavailable.
" is ON (red indicator). After that, you can operate the air
*
HEAT
FAN
* Note: Only for models with heating function.
" button to adjust the time.
8
"
Publicidad
