Publicidad
Clean and maintenance
Clean filter
Open panel
1
Pull out the panel to a certain
angle as shown in the fig.
Remove filter
2
Remove the filter as
indicated in the fig.
WARNING
■ The filter should be cleaned every three months. If there is much dust in the
operation environment, clean frequency can be increased.
■ After removing the filter, do not touch fins to avoid injury.
■ Do not use fire or hair dryer to dry the filter to avoid deformation or fire
hazard.
Clean filter
3
● Use dust catcher or water to
clean the filter.
● When the filter is very dirty,
use the water (below 45ºC )
to clean it, and then put it in a
shady and cool place to dry.
Install filter
4
Install the filter and then close the
panel cover tightly.
13
Publicidad
