Panel Removal - Scotsman C1448R Manual De Instalación

Panel Removal

1. Locate and loosen the two screws at the front
edge of the top panel.
2. Pull the front panel out at the top until it
clears the top panel.
3. Lift the front panel up and off the machine.
4. Remove two screws from the front edge of
the top panel.
5. Lift up the front of the top panel, push it back
an inch, then lift to remove.
6. Locate and loosen the screw holding each
side panel to the base.
7. Pull the side panel forward to release it from
the back panel.
This manual covers several models of remote
cubers. The model number on the ice machine can
be found either on the dataplate, which is on the
back panel, or the serial number tag, which is
behind the front panel. See the illustration for the
locations of the dataplate and the serial number
tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on
the dataplate on the condenser near the quick
connect fittings.
Write the model and serial number of the ice
machine here:
Write the model and serial number of the remote
condenser here:
Write the model and serial number of the ice
storage bin here:
Write the day of initial start up here: That day
starts the warranty period.
Remote Condenser Models - Installation Manual
5
6
1
Panel Removal
Uncrate and Set Up
Begin with the ice storage bin. Remove the carton,
and, using part of the carton as a cushion, tip the
bin on its back to remove the skid. Attach the
supplied legs or optional casters. Return the bin to
a normal, upright position.
Check the bin top gasket for tears or gaps. If
recycling an older bin, replace the gasket or repair
with food grade sealant prior to placing the ice
machine on the bin.
Install the bin top adapter or ice dispenser adapter,
if one is required for the application.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Cut away
any shipping strapping. Lift the ice machine off the
skid directly onto the bin.
Note: The machine is heavy. Use a mechanical lift
if necessary.
Secure the ice machine to the bin with the
hardware provided (two metal straps and four
bolts).
June 2007
Page 7
C1448, C1848, C2148