Publicidad
Idiomas disponibles
Idiomas disponibles
S
S
ETTING
ENSOR
Step 4
Review Screen – The Review Screen lists the selected
settings. At this point you may press Start/Pause to
begin drying the load or select "options" for further
customization of the drying cycle.
Step 6
Review Screen – The review screen will appear
once again to verify your selections. If they are
correct, press Start/Pause. If they are incorrect,
press the area you would like to change.
S
T
ETTING
IME
Step 1
Select "time dry" from the Home screen. The control defaults to
45 minutes.
D
RY
D
RY
Step 5
Options Screen – The option choices on the left turn the options on
or off. The option choices on the right show an additional screen with
multiple choices. The following options may be added to customize
your "sensor dry" cycle:
• "wrinkle prevent" - Intermittent tumble in room temperature air
for up to 95 minutes following the dry cycle.
• "damp dry chime" - Chimes when load reaches damp dry state.
• "remind chime" - Chimes at the end of the cycle every 5 minutes
for up to two hours.
• "end of cycle chime" - Chimes once when the selected dryness
level is reached.
When the desired selections are made, touch "continue" to see the
review screen once again.
Special Note: As you use the touchscreen,
if you feel you are lost, press Back or Home.
Step 2
Press the up and down arrows to set the
appropriate number of minutes to dry the load.
The time will increase or decrease in one minute
increments. Press "continue" when done.
7
Publicidad
