Imetec Zerocalc Z3 3900 Instrucciones De Uso página 16

WARNING! DO NOT use water from dryers, air-conditioners,
water from tumble dryers, filtered water with water softeners
and rain water.
The reservoir may contain some water as each product is tested before being put on the market.
Check that the power supply cable with plug (2) is plugged into the socket.
Move the steam selector (10) to the steam closed position [Fig. C].
Open the water fill cover (9).
Set the iron in a position that facilitates filling the water and prevents it from overflowing.
Slowly fill the water in the reservoir (6) using the water cup (13) [Fig. B].
Do not exceed the maximum fill level shown on the reservoir (6).
Close the water fill cover (9).
TURNING THE IRON ON
Set the iron upright.
Plug the power supply cable with plug (2) into the socket.
Move the on/off switch (3) to the on position to turn on the iron.[Fig.D]
The plate temperature LED (1) indicates that the iron is warming up.
Wait for the plate temperature LED (1) to turn off before starting to iron
INTELLIVAPOR TECHNOLOGY
This steam iron has "Intellivapor" technology which makes it possible to iron all types of fabrics without
adjusting the plate temperature.
It is recommended that you place a cloth between the iron and the fabric when using the iron
for the first time.
Before starting ironing, direct a jet of steam onto the cloth by lifting the iron slightly so that any
residual condensation comes out.
Fabrics with the following symbols may not be ironed:
ECO FUNCTION
The appliance is equipped with new technology that optimises steam production, thereby reducing
energy consumption.
To activate the ECO function, move the steam selector (10) to the ECO steam position.
IRONING WITHOUT STEAM (DRY)
To iron without steam, follow the instructions in the section "steam ironing", leaving the steam selector
(10) in the steam closed position.
IRONING WITH STEAM
Move the steam selector (10) to a position between the closed steam position and the maximum steam
position based on the amount of steam desired.
Continuous steam will only be dispensed when the iron is in a horizontal position.
The continuous steam can be stopped by placing the iron in a vertical position or by moving the steam
selector (10) to the steam closed position.
The plate temperature LED flashes intermittently while ironing, thereby indicating that the
temperature is maintained.
EN
14