Imetec Zerocalc Z3 3900 Instrucciones De Uso página 17

SUPER-STEAM AND STEAM IN A VERTICAL POSITION
EN
Press the super-steam button (12) to generate a strong shot of steam.
Wait a few seconds between each pressing action of the iron [Fig. E].
Press the super-steam button (12) intermittently to iron vertically (drapes, hanging garments, etc.).
NOTE: Stop using the super-steam button (12) when the plate temperature LED (1) lights
up and start ironing again only when it turns off to prevent water droplets from dripping
from the plate.
SPRAY FUNCTION
Verify that there is water in the reservoir (6).
Press the spray button (11) slowly (for a dense spray ) or quickly (for a mist) [Fig. F].
Dampen delicate fabric using the spray function before ironing or alternatively lay a damp cloth
between the fabric and the iron. Do not use the spray function on silk or synthetics.
EMPTYING
Move the on/off switch (3) to the off position to turn off the iron [Fig.D].
Unplug the power supply cable with plug (2) from the socket.
Open the water fill cover (9).
Empty the reservoir (6) by turning the iron upside down and shaking it lightly.
Let the iron cool down completely.
Always set the iron upright.
NOTE: If the appliance is not to be used for several weeks, wait for the appliance to
cool down completely before emptying the water reservoir completely according to the
instructions in the relevant chapter.
When the appliance is switched on again, refill the reservoir as indicated in the relevant
chapter.
ZEROCALC ANTI-CALC SYSTEM
Three special resin filters located inside the water reservoir decrease the water hardness and limit the
formation of limescale in the plate. These resin filters are permanent and do not require replacement.
CALC CLEAN SYSTEM
This function is used to clean the inside of the iron's plate (7) from limescale residues or other impurities.
It is recommended to implement this function every 5 - 10 times it is used.
Fill the reservoir (6) to the maximum fill level [Fig. B].
Move the steam selector (10) to the steam closed position [Fig. C].
Wait for the plate temperature control LED (1) to turn off.
Unplug the power supply cable with plug (2) from the socket and put the iron in a horizontal position
over a sink.
Press the calc-clean (4) button, and hold it until hot water, steam and any impurities or limescale come
out of the plate (7).
15
END OF USE
MAINTENANCE AND STORAGE