COMPONENTS
FIG. 5
F
A
A - Recoil starter grip
B - Control panel
UNDERSTANDING YOUR GENERATOR
See Figures 5 - 6.
To reduce the risk of injury and product failure, read and
understand the information in this user's manual as well as
the information on the product labeling.
120 VOLT AC RECEPTACLES
This unit has two 120V, 18A receptacles capable of powering
a variety of appliances, tools, and equipment.
CO SENSOR INDICATOR LIGHTS
The CO Sensor monitors for the accumulation of poisonous
carbon monoxide gas. If increasing levels of CO gas are de-
tected, the CO Sensor automatically shuts down the engine.
ECO MODE SWITCH
Eco mode minimizes fuel consumption and noise by ad-
justing the engine RPM to the minimum required for the
current load.
FUEL TANK
The generator has a fuel tank with a capacity of 0.98 gallons
(3.7 liters).
GROUND TERMINAL
The ground terminal is used to externally ground the
generator.
LED DATA CENTER
Toggle to show voltage, frequency, total hour meter, and
run/maintenance timer.
D
E
B
C - Muffler/spark arrestor
D - Fuel cap
MUFFLER AND SPARK ARRESTOR
The spark arrestor prevents sparks from exiting the muffler.
It must be removed for servicing.
OIL DIPSTICK
Unscrew the oil dipstick to check oil levels and add oil when
needed.
OUTPUT READY LED
Illuminates when the generator is operating normally. In-
dicates the generator is producing electrical power at the
receptacles.
OVERLOAD RESET
The generator inverter will automatically switch OFF all AC
output to protect the generator if overloaded or if there is a
short circuit in a connected appliance.
RECOIL HANDLE
Use the recoil handle (and the engine/fuel control switch)
to start the generator.
SPARK PLUG SERVICE DOOR
Lift the spark plug service door to access the spark plug.
USB PORTS
Two-port 5V/2.1A USB outlet accepts Type A USB plugs.
F
E - Spark plug access cover
F - Service panel
NOTICE
The spark arrestor is a safety device
that prevents sparks from exiting the muffler and cre-
ating a fire hazard. In certain locations a spark arrestor
may be required by law. It is the operator's responsi-
bility to know and follow all local laws and regulations
related to fire prevention requirements.
C
English | 11