EGO HTX5310-P Manual Del Operador página 27

STARTING/STOPPING THE HEDGE TRIMMER
Before operating, remove the blade sheath and hold the trimmer with both hands, one
hand on the rear handle and the other on the front handle. Then check for balanced
footing, upright standing and a proper cutting distance. Make sure that the cutting
blade is not touching the ground or any other objects.
To start the machine (Fig. 7)
1. Install the battery pack.
2. Move the lock-off lever forward and
then press the trigger switch to start
the machine. The speed of the hedge
trimmer is controlled with the trigger
switch. More pressure on the trigger
results in higher speed; less pressure
on the trigger results in lower speed.
Adjust the speed to suit the task at
hand.
NOTICE:
The motor starts only when the lock-off lever is moved forward and the
trigger switch is depressed at the same time.
To stop the machine
Move the machine away from the cutting area and release the trigger switch to stop it.
WARNING:
breaks and after finishing work.
56-VOLT LITHIUM-ION COMMERCIAL 21" EXTENDED POLE HEDGE TRIMMER — HTX5310-P/HTX5310-P-FC
Always remove the battery pack from the machine during work
7
a
b
27