Publicidad
Step 5
å
Turn three BLACK 9/16" FLAT HEAD SCREWS (32S) into the
MODESTY PANEL (G) until the shoulders of the SCREWS rest on
the surface of the MODESTY PANEL.
å
NOTE: Do not overtighten the SCREWS.
å
Slide a MODESTY PANEL MOLDING (S) onto the MODESTY
PANEL (G). Line up the groove in the MOLDING over the heads of
the SCREWS in the MODESTY PANEL.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it
and slide it on again. The MOLDING should be centered
over the MODESTY PANEL.
å
Turn the MODESTY PANEL (G) over and
repeat this step to the other surface
of the MODESTY PANEL.
S
Page 10
S
G
S
428729
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
G
Apply pressure with your hands as you
guide the MOLDING over the SCREWS
and onto the MODESTY PANEL.
32S
32S
Shoulder
www.sauder.com/service
Publicidad
