Publicidad
Step 22
1
D28
W
Groove
å
Insert the LARGE DRAWER SIDES (D28 and D29)
at an angle into the slot at each end of the LARGE
DRAWER FRONT (W).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER SIDES (D28
and D29). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the LARGE DRAWER BOTTOM (D707) inserts into the groove
of the LARGE DRAWER BACK (D78).
å
Repeat this step for the other LARGE drawer.
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D29
D78
D28
D707
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the LARGE DRAWER BOTTOM (D707) into the
grooves in the LARGE DRAWER SIDES (D28 and D29)
and LARGE DRAWER FRONT (W).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D29
428729
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
D707
D28
D29
W
30S
(8 used in this step)
9
Page 27
Publicidad
