Publicidad
Step 4
å
Turn the ENDS (A and B), UPRIGHTS (D2 and E2), and BACKS (F) over.
å
Turn twelve BLACK 9/16" FLAT HEAD SCREWS (32S) into the ENDS (A and B), UPRIGHTS (D2 and E2), and BACKS (F)
until the shoulders of the SCREWS rest on the surfaces of the ENDS, UPRIGHTS, and BACKS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDINGS (I and K) onto the ENDS (A and B), UPRIGHTS (D2 and E2), and BACKS (F). Line up the grooves in
the MOLDINGS over the heads of the SCREWS in the ENDS, UPRIGHTS, and BACKS.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again. The MOLDINGS should be centered
over the ENDS, UPRIGHTS, and BACKS.
F
K
B
I
www.sauder.com/service
K
F
A
E2
I
428729
BLACK 9/16" FLAT HEAD SCREW
(12 used in this step)
I
D2
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the ENDS, UPRIGHTS, and BACKS.
32S
I
Shoulder
Page 9
Publicidad
