Publicidad
Step 12
å
Turn the UPRIGHTS (D2 and E2) over.
å
Fasten the EXTENSION BLOCKS (T) to the UPRIGHTS (D2 and E2). Use four BLACK 1-1/4" FLAT HEAD SCREWS (7S).
å
Fasten the remaining two NARROW EXTENSION RAILS (40NA) to the UPRIGHTS (D2 and E2). Use four GOLD 5/16"
FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each NARROW EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then,
slide the inner cartridge of the NARROW EXTENSION RAIL in to find the other hole that lines up with the hole in the
EXTENSION BLOCK.
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
4
3
Open end
2
1
T
H
www.sauder.com/service
3S
Surface with
more holes
Unfinished
strip
The large hole
must be here.
E2
1
2
3
4
T
428729
Open end
BLACK 1-1/4" FLAT HEAD SCREW
(4 used for the EXTENSION BLOCKS)
P
D2
7
7S
Page 17
Publicidad
