Publicidad
Step 10
å
Separate the WIDE EXTENSION SLIDES (40MC) from the WIDE EXTENSION RAILS (40MA) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten the WIDE EXTENSION RAILS (40MA) to the ENDS (A and B) and UPRIGHTS (D2 and E2). Use eight GOLD 5/16"
FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the WIDE EXTENSION RAIL in to find the other hole that lines up with the hole in the END and UPRIGHT. Turn
a SCREW into this hole.
å
NOTE: The WIDE EXTENSION SLIDES will be used later for the LARGE DRAWERS.
Push the black lever in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used for the RAILS)
Edge with
TWIST-LOCK®
FASTENERS
P
Open end
Edge with
TWIST-LOCK®
FASTENERS
P
Open end
www.sauder.com/service
40MC
B
4
3
2
1
40MA
D2
3
2
1
A
E2
4
40MA
428729
40MA
H
1
2
3
4
H
1
2
3
4
40MA
7
Open end
Open end
Page 15
Publicidad
