Publicidad
Step 11
å
Separate the NARROW EXTENSION SLIDES (40NC) from the NARROW EXTENSION RAILS (40NA) as shown in the
upper diagram below. Be prepared, the parts are greasy.
å
Fasten eight NARROW EXTENSION RAILS (40NA) to the ENDS (A and B) and UPRIGHTS (D2 and E2). Use sixteen
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each NARROW EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide
the inner cartridge of the NARROW EXTENSION RAIL in to find the other hole that lines up with the hole in the END and
UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The NARROW EXTENSION SLIDES will be used later for the SMALL DRAWERS and PENCIL DRAWER.
40NC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(16 used for the RAILS)
4
40NA
3
2
1
2
1
Open end
40NA
2
1
1
Open end
Page 16
3S
4
3
B
4
3
4
3
2
D2
40NA
1
40NA
2
1
3
4
2
3
4
A
40NA
2
3
4
3
4
428729
Open end
Open end
1
1
2
E2
www.sauder.com/service
7
Publicidad
