Publicidad
Step 28
å
To make adjustments to the SMALL DRAWERS, loosen SCREW #3 in the SLIDES a 1/4 turn, then turn the CAM clockwise
or counter-clockwise. Notice how the drawer raises or lowers as you turn the CAM. The higher the screw in the oblong
hole, the higher your drawer front will be. The lower the screw, the lower the drawer front. By adjusting the drawers this
way, it will help the DRAWER FRONTS line up better when closed. Tighten the SCREW when finished with adjustments.
å
NOTE: Loosen screw #4 to make adjustments to the LARGE DRAWERS.
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with a damp cloth. Wipe dry.
And to celebrate, why not share your success story at sauder.com or
Loosen screw #3 a 1/4 turn, turn the cam a 1/4 turn
maximum in both the clockwise and counter-clockwise
directions to make adjustments, and then tighten screw #3.
The higher the screw in the oblong hole,
the higher your drawer front will be. The
lower the screw, the lower the drawer front.
www.sauder.com/service
3
2
Cam
428729
13
Page 33
Publicidad
