Steam Gun; Detail Nozzle; Hand Nozzle; Floor Nozzle - Kärcher SC 2.500 C Manual De Instrucciones

Ocultar thumbs Ver también para SC 2.500 C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

be created. When cleaning these sur-
faces, briefly steam a cloth and wipe
the surfaces with it.
Caution
Never direct the steam jet at
glued edges as the edge band
may loosen. Do not use the
steam cleaner on unsealed
wooden or parquet floors.
Cleaning of Glass
In case of low outside temperatures,
especially in the winter, warm up the
window pane by slightly steaming the
entire glass surface. This will prevent
tensions on the surface which might
lead to glass breakage.
Then clean the window surface with
the hand nozzle and attachment. Use a
squeegee to remove the water or wipe
the surfaces dry.
Caution
Do not direct steam onto the
sealed locations of the window
frame to prevent damage.

Steam gun

You can use the steam gun without
any additional accessories, e.g.:
to remove odours and wrinkles from
hanging clothes by steaming them
at a distance of 10 to 20 cm.
to remove dust from plants. Here,
keep a distance of 20-40 cm.
for moist dusting, by briefly steam-
ing the cloth and wiping the furni-
ture with it.

Detail nozzle

The closer this nozzle is to the contam-
inated area, the higher the cleaning ef-
fect, as the temperature and the steam
are highest at the nozzle output. Espe-
cially suited for cleaning difficult ac-
cess locations, joints, fittings, drains,
sinks, toilets, blinds and heaters.
Heavy lime scale can be drenched in
vinegar prior to steam-cleaning. Let the
vinegar penetrate for about 5 minutes.
Round brush
The round brush can be installed onto
the detail nozzle as an accessory. At-
tached brushes can therefore be used
to remove heavy soiling.
Caution
Not suited for the cleaning of
sensitive surfaces.
Illustration
Attach the round brush to the detail
nozzle.

Hand nozzle

Pull the terry cloth cover over the hand
nozzle. Especially well-suited for small
washable areas, shower stalls and mir-
rors.

Floor nozzle

Note:
Detergent residue or care emul-
sions that are still present on the
surfaces to be cleaned, can lead
to smears when steam cleaned.
However, these will disappear
with repeated cleaning proce-
dures.
Illustration
Attach the floor cloth to the floor
nozzle.
1 Fold the floor cloth the long way and
place the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the open-
ings.
4 Close the holding clamps.
English 27

Publicidad

Tabla de contenido
loading

Tabla de contenido