Steam Gun; Detail Nozzle; Hand Nozzle; Floor Nozzle - Kärcher SC 2 Manual De Instrucciones

Cleaning of Glass
In case of low outside temperatures, espe-
cially in the winter, warm up the window
pane by slightly steaming the entire glass
surface. This will prevent tensions on the
surface which might lead to glass break-
age.
Then clean the window surface with the
hand nozzle and attachment. Use a squee-
gee to remove the water or wipe the surfac-
es dry.
ATTENTION
Do not direct steam onto the sealed loca-
tions of the window frame to prevent dam-
age.

Steam gun

You can use the steam gun without any ad-
ditional accessories, e.g.:
to remove light wrinkles from hanging
–
clothes by steaming them at a distance
of 10 to 20 cm.
to remove dust from plants. Here, keep
–
a distance of 20-40 cm.
for moist dusting, by briefly steaming
–
the cloth and wiping the furniture with it.

Detail nozzle

The closer this nozzle is to the contaminat-
ed area, the higher the cleaning effect, as
the temperature and the steam are highest
at the nozzle output. Especially suited for
cleaning difficult access locations, joints,
fittings, drains, sinks, toilets, blinds and
heaters. Heavy lime scale can be drenched
in vinegar prior to steam-cleaning. Let the
vinegar penetrate for about 5 minutes.
Round brush
The round brush can be installed onto the
detail nozzle as an accessory. Attached
brushes can therefore be used to remove
heavy soiling.
ATTENTION
Not suited for the cleaning of sensitive sur-
faces.
Illustration
 Attach the round brush to the detail noz-
zle.
Pull the terry cloth cover over the hand noz-
zle. Especially well-suited for small washa-
ble areas, shower stalls and mirrors.
Suited for all washable walls and floor cov-
erings, e.g. stone floors, tiles and PVC
floors. Work slowly on very dirty surfaces to
allow the steam to act on the dirt for a long-
er period of time.
Note
Detergent residue or care emulsions that
are still present on the surface to be
cleaned can lead to streaks during steam
cleaning. However, these will disappear
with repeated cleaning procedures.
Illustration
 Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth the long way and
place the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
ATTENTION
Do not insert fingers between the clamps.
Parking the floor nozzle
Illustration
 During work breaks, hook the floor noz-
zle into the parking holder.
– 11
EN

Hand nozzle

Floor nozzle

21