Publicidad
Idiomas disponibles
Idiomas disponibles
English
Taper shank adaptor
Drill bit
(Taper shank)
(2) Turn the power on and drill a base hole.
(3) After cleaning out dust with a syringe, attach the plug
to the anchor tip and drive in the anchor with a manual
hammer.
(4) To remove the drill bit with taper shank, insert a cotter
into the slot of the taper shank adaptor, place supports
under the Rotary Hammer and tap the cotter with a
manual hammer. (Fig. 13)
Cotter
Support
USING DRILL CHUCK, CHUCK ADAPTOR
Note that this machine can be used at "rotation only"
if separately sold parts such as drill chuck and chuck
adaptor are attached. Use it with the selector lever
positioned at "rotation + hammering".
WARNING
During operation, be sure to grip the handle and
the side handle fi rmly to prevent your body from
swaying.
(1) Switching to "rotation + hammering"
For switching to "rotation + hammering", follow the
same procedures mentioned in [3. When drilling at
"rotation + hammering"] in Page 8.
(2) Attaching chuck adaptor to drill chuck (Fig. 14)
(a) Attach the chuck adaptor to the drill chuck.
(b) The SDS max shank of the chuck adaptor is
equivalent to the drill bit. Therefore, follow the
same procedure as [6. How to install tool] in Page
7 for attaching and detaching.
10
Fig. 12
Taper shank
adaptor
Fig. 13
SDS max shank
Drill
Chuck
chuck
adaptor
(3) Drilling
(a) Even if you apply more-than-required pressure
to the machine body, drilling can never be
performed as quickly as you expect. Applying
more force or pressure to the machine body
than what is needed, on the contrary, damages
the drill tip, resulting in the declined working
effi ciency and shortened life of this machine.
(b) A drill can snap sometimes when drilling is almost
fi nished. It is important to relax your thrusting
pressure when drilling is nearing the end.
HOW TO USE THE CORE BIT
When boring penetrating large hole use the core bit. At
that time use with the center pin and the core bit shank
provided as optional accessories.
1.
Mounting
CAUTION
Be sure to turn power OFF and disconnect the
plug from the receptacle.
(1) Mount the core bit to the core bit shank. (Fig. 15)
Lubricate the thread of the core bit shank to facilitate
disassembly.
Core bit
Grip
Fig. 14
Core bit shank
Fig. 15
Publicidad
