2
Select a preset picture tone.
NORMAL
Normally select this.
CINEMA
Suitable for a movie source.
USER1/USER2
You can adjust parameters and can
store the settings (see below).
To adjust the picture tone
1
Select "USER1" or "USER2."
• Follow steps 1 and 2 explained on the previous page.
2
Select a parameter you want to adjust.
GAMMA
Adjust if the neutral color is bright
or dark. The brightness of dark and
bright portions is maintained
(–3 to +3).
BRIGHTNESS
Adjust if the picture is bright or
dark as a whole (–8 to +8).
CONTRAST
Adjust if the far and near position
is unnatural (–7 to +7).
SATURATION
Adjust if the picture is whitish or
blackish (–7 to +7).
TINT
Adjust if the human skin color is
unnatural (–7 to +7).
SHARPNESS
Adjust if the picture is indistinct
(–8 to +8).
3
Adjust the parameter.
4
Repeat steps 2 to 3 to adjust other parameters.
To erase the VFP screen, press VFP again.
NORMAL
CINEMA
USER2
USER1
ENTER
ENTER
Changing the Display Brightness
DIMMER 1
DIMMER
DIMMER OFF
(Canceled)
DIMMER 1
Dims the display and the illumination
on the main unit*.
DIMMER 2
Dims the display (same as DIMMER 1)
and turns off the illumination on the
main unit*.
* Except for the RHYTHM AX and KARAOKE SCORING
lamps.
Setting the Clock
Without setting the build-in clock, you cannot use any
timers.
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To correct a misentry during the process, press CANCEL.
You can return to the previous step.
1
Activate clock setting mode.
CLOCK/
TIMER
• If you have already adjusted the clock before, press the
button repeatedly until the clock time starts flashing.
2
Adjust the hour, then minute.
L
BALANCE
R
Now the built-in clock starts working.
Turning Off the Power Automatically
With Sleep Timer, you can fall asleep while listening to
music.
1
Specify the time (in minutes).
SLEEP
10
Canceled
2
Wait until the set time goes off.
To check the time remaining until the shut-off time
SLEEP
• If you press the button repeatedly, you can
change the shut-off time.
Remote
ONLY
DIMMER 2
Remote
INFO
ONLY
SET
Remote
ONLY
20
30
60
90
150
120
15