Electrolux ENV9MD18S Manual De Instrucciones página 29

Problem
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
appears on the
display.
Possible cause
Stored food was not wrap‐
ped.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The Extra Freeze function
or Extra Cool function is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The Extra Freeze function
is switched on.
The Extra Cool function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in the
demonstration mode.
ENGLISH
Solution
Wrap food in suitable
packaging before storing it
in the appliance.
Attach the melting water
outlet to the evaporative
tray.
Switch off Extra Freeze
function or Extra Cool func‐
tion manually, or wait until
the function deactivates
automatically to set the
temperature. Refer to "Ex‐
tra Freeze function" or "Ex‐
tra Cool function" section.
Set a higher/lower temper‐
ature.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "Extra Freeze
function" section.
Refer to "Extra Cool func‐
tion" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and tips" chapter.
To exit the demonstration
mode, press and hold the
Extra Cool and ECO but‐
tons for approximately 10
seconds until you hear 3
short beeps.
29