Zhermack zetaclave B Manual De Uso Y Mantenimiento página 151

MAINTENANCE AND USE MANUAL
• Connect the plug to the mains socket. Do not replace the original plug with other types; do not
make additional connections; do not connect to multiple plugs or similar: ensure that the installa-
tion to which the sterilizer is connected complies with all relevant legislation and can sustain the
specified load (paragraph 4.2).
• Open the door by pushing the DOOR button.
• Take the accessory kit out of the box and switch the equipment off.
Carefully read paragraphs 6.5 and 6.5.1 before starting normal operation.
Should it be necessary to move the Zetaclave B proceed as follows:
1. disconnect the equipment from the mains power supply
2. if necessary, empty the water contained in the boiler;
3. hold the equipment by the handle, making sure that you keep it in a vertical position at all times. To
this end of, always bear in mind the weight and dimensions of the unit being handled (see section
4.2.2) so as to prevent any damage caused by inobservance of
these measurements.
4. pack the Zetaclave B in its original box or, if this is not possible, take all the necessary precautions to
protect the steam cleaner against knocks or drops, in that the goods are transported at the owner's
risk.
The autoclave is fragile and should therefore be transported with extreme care.
DO NOT TURN UPSIDE DOWN.
Failure to observe the above exonerates the Manufacturer from any liability
concerning equipment malfunction and consequently renders the Warranty null
and void.
When shipping/delivering the equipment to your Authorised Servicing Centre
always enclose a copy of the purchase document and a copy of the properly
compiled ID form.
If the unit is to be transported by courier, the postal service or rail it is
recommended such shipments be insured.
When disposing of the packaging materials the user must comply with the standards in force in his/
her country regarding the following materials:
• Wood/paper: non-polluting materials, but must be recycled properly.
• Polystyrene/plastic: pollutants which must not be burnt (toxic fumes) nor dispersed into the
environment, but disposed of in compliance with the standards in force in the country of use.
If the equipment is to be dismantled the user must, in compliance with EC directives and the laws in
force in the country of use, effect elimination and recycling of the following materials:
• Plastic and glass parts, insulated electrical wiring, rubber parts.
• There are no toxic or corrosive parts.
zetaclave B
EN
TRANSPORT AND MOUNTING
DISPOSAL/DISMANTLING
5.3
5.4
151 of 228