Publicidad
Idiomas disponibles
Idiomas disponibles
1. Connect the suction hose with filter bas-
ket (11) to the coupling on the device.
2. Insert the end with the filter basket into
the water collector (e.g. rain barrel).
Ensure there is a sufficient and reliable
water supply.
Weight down the filter basket so
that it sinks in the water.
When suctioning, the device may
run dry temporarily.
Bleeding the hose
Make sure that there is no air in the suction
hose. Immerse the suction hose and filter
basket (11) completely into the water col-
lector (e.g. rain barrel) to bleed it.
Dry running will damage the device
Inserting/removing the
rechargeable battery
1. To insert the battery (13) into the de-
vice, push the battery (13) along the
guide rail into the device. You will hear
it click into place.
2. To remove the battery (13) from the
device, press the release button (14)
on the battery and pull the battery (13)
out.
Attaching the spray lance/
cleaning agent nozzle
1. Connect the spray lance (9) or the
cleaning agent nozzle (7) to the cord-
less pressure washer by inserting and
screwing in (bayonet locking device).
2. Attachments are removed in reverse
order.
Operation
Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
standing firmly and that you
are holding the gun securely,
otherwise you could injure
yourself or other people.
Never operate the pressure cleaner
with a closed water tap. Dry run-
ning will damage the pressure
cleaner!
1. Only use the device after you have con-
nected the water supply and the con-
nection is tight.
2. Press the release button (2) and then
the switch lever (3). You can then let go
of the release button (2).
3. Releasing the switch lever (3) switches
off the device.
If there is a leak in the water
system, switch off the device
immediately and remove
the battery. Risk of electric
shock! Try connecting the
water again (see "Initial
start-up - connecting the wa-
ter supply").
Ending operation
1. After having worked with a detergent
rinse the pressure cleaner with clear
water.
2. Release the switch lever (3).
3. Remove the battery from the device.
4. Disconnect the cordless pressure wash-
er from the water supply.
5. Press the release button (2) and the
switch lever (3) to release the existing
pressure in the system.
GB
MT
25
Publicidad
