Descargar Imprimir esta página

cecotec ENERGY SILENCE AERO 5285 CONNECTED Manual De Instrucciones página 45

Ventilador de techo

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 36
Winter Function
Press button 3 to activate the winter function. The fan will make air flow from the bottom
upwards, bringing cold air to the top of the room.
Summer Function
Press button 4 to activate the summer function. The fan will make air flow from the top
downwards, bringing cold air to the bottom of the room.
Warning:
Invert the spinning direction of the fan while in operation. Hold down the button for approx.
3 seconds: the appliance will beep, and the blades will start slowing down until they stop
spinning. After a few seconds, they will start spinning again in the opposite direction.
Natural breeze
Activate this mode by pressing button 5. The fan will run at different power levels in a cycle,
producing a feeling of fresh air.
Pairing the remote control with the fan
Press the OFF button for 5 seconds until you hear a beep.
Wi-Fi connection
Press the 1h and 4h button simultaneously for 5 seconds until you hear a beep. Follow the
instructions in section 5. Wi-Fi connectivity and mobile App.
Warnings:
-
If the fan cannot be controlled through the remote control, check if the batteries in the
remote control are in good conditions and if the make good contact, that the positive and
negative electrodes are in the correct position, and if the batteries are charged.
-
If the fan cannot be controlled through the remote control, check if there are other remote-
controlled appliances in the same area and check if the transmitter buttons are pressed.
Appliances with similar remote-control systems may cause interference. This does not
include infrared remote controls.
-
Pay attention to the appliance voltage. Too low a voltage may cause the remote control to
not work. The technical specifications are indicated in this manual.
-
If the remote control is not going to be used for a long time, remove the batteries.
Changing the remote control battery
The remote control requires 2 x 1.5 V-3 AAA batteries.
1.
Open the battery compartment.
2. Insert the batteries into the battery compartment observing the polarity.
3. Close the compartment.
ENERGYSILENCE AERO 5285 CONNECTED | ENERGYSILENCE AERO 5500 AQUA CONNECTED
ENGLISH
45

Publicidad

loading