Metabo SB 18 LTX BL I Manual Original página 11

8. Troubleshooting
8.1 Defective electronic safety shutdown
Red continuous lighting of the LED lamp (14)
signals a defective safety shutdown.Have the
machine repaired. See chapter 10.
8.2 The machine's multifunctional
monitoring system
If the machine switches off automatically, the
machine electronics have activated automatic
protection mode. There will be a warning signal
(beep). The beeping stops after a maximum of 30
seconds or when the trigger switch (15) is released.
In spite of this protective function, overloading
is still possible with certain applications and
can result in damage to the machine.
Causes and remedies:
1. Battery pack almost empty
electronics protect the battery pack against
damage through total discharge).
If one LED (11) is flashing, the battery pack is
almost flat. If necessary, press the button (10)
and check the LED lamps (11) to see the charge
level. If the battery pack is almost flat, it must be
recharged.
2. Long continuous overloading of the machine will
activate the temperature cut-out.
Leave the machine or battery pack to cool.
Note: if the battery pack feels very warm, the
pack will cool more quickly in an "AIR COOLED"
charger.
Note: the machine will cool more quickly if you
operate it at idling speed.
3. Metabo safety shutdown: the machine has
SHUT DOWN by itself. If the speed suddenly
drops (for example, if the machine suddenly
seizes or kickback occurs), the machine
switches off. Switch off the machine at the
trigger switch (15). Switch it on again and
continue to work as normal. Try to prevent the
machine from seizing.
8.3 Note:
The LED lamp (14) switches off automatically after
a specific time.
9. Accessories
Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
Fit accessories securely. If the machine is operated
in a holder: secure the machine well. Loss of control
can cause personal injury.
See www.metabo.com or the catalogue for a
complete range of accessories.
10. Repairs
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
11. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
Fig. A, B (The
water!
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).
12. Technical Data
improvements.
U
n
0
Tightening torque for screwing:
M
1
M =Pulse torque
2
M
3
M
4
Max. drill diameter:
D
1 max
D
2 max
D
3 max
s
m
G
D
max
Permitted ambient temperature during operation:
-20 °C to 50 °C (limited performance with
temperatures below 0 °C). Permitted ambient
temperature for storage: 0 °C to 30 °C
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Repairs to electrical tools must only be carried
out by qualified electricians!
Fig. K. We reserve the right to make technical
= Voltage of battery pack
= No-load speed
= Soft screwing application (wood)
= Hard screwing applications (metal)
= Adjustable torque
= in steel
= in softwood
= in masonry
= Max. impact rate
= Weight (with the smallest battery pack)
= Spindle thread
= Chuck clamping range
Emission values
These values make it possible to assess the
ENGLISH en
11