Belt Replacement - Hoover WindTunel Manual De Instrucciones

5. Insert agitator brush roll
through belt and position belt
over gear teeth (D) on agitator brush
roll.
6. With curved ends down,
slide end plates (C) of agitator
brush roll into slots (E) on tool.
7. Replace belt guard (B) mak-
ing sure not to pinch brush bris-
tles in guard. Turn agitator brush roll,
to make sure it rotates freely.
Replace and tighten screws.
Q8. To replace bottom plate (A),
insert the four tabs on edge of
bottom plate into slots on front of
tool.
Pivot bottom plate down and snap
closed.
Belt replacement
Inspect the belt
The powered pet hair cleaning too[
belt is designed to last a long time
and is not normally replaced.
However, if the belt is cracked,
gouged or broken, it should be
replaced.
Remove tool from hose. The belt can
be seen through the top of the nozzle
or by removing the bottom plate and
belt guard (Figs. 47 and 48).
Replace belt
When replacing belt, ask for
HOOVER part No. 38528037.
1. Remove bottom plate, belt guard
and agitator brush roll as described in
Figs. 47 through 49.
_2. Grasp turbine (E) and pull
firmly to remove.
3. Remove belt from turbine pulley
(F). Replace with new belt.
(Cont'd) --_
15