Brush Roll - Hoover WindTunel Manual De Instrucciones

Check agitator brush roll
When agitator brush roll brushes are
worn, the agitator brush roll should be
replaced.
To check condition of brushes, turn
cleanerOFF and disconnectfrom elec-
trical outlet.
©
What to buy
When purchasing a new agitator })rush
roll, ask for HOOVER part no.
48414140.
How to replace
Turn cleaner ON and rotate mode con-
trol dial to HARD FLOOR. Turn cleaner
OFF and disconnect from electrical out-
let. Place handle in upright position and
turn cleaner over so bottom side is up.
Q emove the five screws as shown
with a Phillips screwdriver. Lift off
bottom plate (A).
Q Move edge of a card across bot-
tom plate while turning agitator
})rushroll. To maintain cleaning effec-
tiveness, replace agitator })rushroll if
})rushes do not touch card.
Pull up on agitator brush roll (C)
to remove from })rushroll cavity.
_Ii olding agitator })rushroll with
one hand, slide belt (D) off the
agitator })rushroll.
NOTE: Hold on to the belt with one
hand. Do not allow the belt to fall back
into the cavity on bottom of (leaner.
Q old new agitator })rushroll in
one hand; the belt in the other.
Slide the belt onto the agitator })rush
roll, positioning the belt in the belt guide
(E)on the agitator })rushroll.
(Cont'd) --* 1 3