Preparation Before Operation - Hitachi Koki C 10FSH Instrucciones De Manejo

Slide compound miter sawingletadora telescopica
Ocultar thumbs Ver también para C 10FSH:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Installation
5-29/32"(150mm)
11/32" (9mm)
3 Holes
11-13/16" (300mm)
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 5/16" (8mm) diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 1-9/16" (40mm) plus the thickness of the work bench.
For example, use 2-9/16" (65mm) or larger bolts for a 1" (25mm) thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
6mm Bolt
Holder
Adjust the holder
Move
until its bottom
surface contacts the
work bench surface.
Fig. 5
2. Releasing the locking pin
Handle
Pull
Locking Pin
Fig. 6
3. Installing the dust bag, holder, stopper and vises
(The holder and stopper are optional accessories.)
Attach the dust bag and vise assembly as indicated in Fig. 1 and Fig. 2.
Base
Fig. 4
Holder adjustment:
Loosen the 6mm bolt with the supplied 10mm box wrench.
Adjust the holder until its bottom surface contacts the work bench
surface.
After adjustment, firmly tighten the 6mm bolt.
When the power tool is prepared for shipping, its main parts are
secured by a locking pin.
Move the handle slightly so that the locking pin can be disengaged.
NOTE:
Lowering the handle slightly will enable you to disengage
the locking pin more easily and safely.
The lock position of the locking pin is for carrying and
storage only.
5/16" (8mm) Bolt
Work Bench
5/16" (8mm) Nut
English
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

C 10fsb

Tabla de contenido