Publicidad
Idiomas disponibles
Idiomas disponibles
˜ Use
˜ Inserting a glue stick
Push the glue stick
o
NOTE
Do not pull out the glue stick
This could damage the product.
˜ Switching on
Switch on the product: Press and hold the on/off button
o
approx. 3 seconds. The battery status indicator
light
lights up white.
[
9 ]
Allow the product to heat up for approx. 15 seconds.
o
The battery status indicator
reached working temperature. The product is now ready for use.
˜ Gluing
m
WARNING!
If hot glue comes into contact with skin, a serious burn may occur. Run under
u
cold water for several minutes and seek medical attention if required.
Residual glue may result in dripping. Ensure that work surface is suitably
u
protected from dripping glue.
Avoid contact with the hot nozzle
u
Wear heat resistant gloves when using this product.
u
1. Place the nozzle
2. Pull the trigger
Release the trigger to stop the glue flow.
into the feeder shaft
4 ]
[
lights up green as soon as the product has
8 ]
[
close to the work surface.
1 ]
[
slowly, until the melted material begins to flow from the nozzle.
[
]
.
[
3 ]
of the feeder shaft
4 ]
[
lights up red and the LED work
8 ]
[
.
1 ]
[
.
3 ]
[
for
7 ]
[
GB/IE
41
Publicidad
