Lenco DAR-061BK Manual Del Usuario página 8

1. Getting stared
BATTERY INSTALLATION (REMOTE CONTROL)
1: Connect the DC mains plug to the DC mains input socket on the rear of the unit.
2: Connect the plug to a mains outlet and switch on.
Battery installation (Batteries not included):
1. Press the tab on the battery door and lift it off.
2. Install two (2) x AAA size batteries into the battery compartment as the figure on right
and the polarity markings, inside the battery compartment.
3. Replace the battery door.
Battery Precautions:
Follow these precautions when using a battery in this device:
1. Use only the size and type of battery specified.
2. Beware to follow the correct polarity when installing the battery as indicated in the
battery compartment. A reversed battery may cause damage to the device.
3. Don't throw batteries into a fire. They may explode or leak.
4. Clean the battery contacts and also those of the device prior to battery installation.
5. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old
batteries with fresh ones.
6. If the batteries in the device are consumed or the device is not to be used for a long
period of time, remove them.
7. Do not try to recharge the battery not intended to be recharged; it can overheat and
rupture.
2.1 The packaging box contains following items:
SYSTEM SETTINGS
Standby & power on mode
1: Press and hold the POWER/MODE button to put the system into ON or STANDBY mode.
The date and time are displayed during standby.
2: When in standby mode press the POWER/MODE to power on.
8