Amanngirrbach Giroform Modo De Empleo página 35

5.8.3 With setting pins (Giroform Classic)
▷ Set 3 pins into the model plate.
Fig. 38
▷ Block out the pin tips with putty, put a space
retainer foil on it.
Fig. 39
▷ Apply plaster on both sides and close the artic-
ulator without applying pressure.
Fig. 40
C L E A N I N G A N D M A I N T E N A N C E
6 Cleaning and Maintenance
6.1 Cleaning
▷ Switch the machine off via the main switch.
▷ If required, blow out drilling dust with com-
pressed air.
▷ Carefully wipe the surfaces of the machine with
a soft cloth.
6.2 Maintenance
6.2.1 Adjusting the drilling depth
The drill bit rests on a slotted screw in the centre
of the axis. By turning the screw, the drilling depth
and thus the width of the hole and the pin protru-
sion can be changed:
To sink the pins in deeper:
▷ Turn the screw anti-clockwise using the adjust-
ment screwdriver.
To make the pins protrude further:
▷ Turn the screw clockwise using the adjustment
screwdriver.
Fig. 41
E N
35