Descargar Imprimir esta página

ELICA ESC128SS Guía De Instalación, Uso Y Mantenimiento página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

COMPLETE INSTALLATION
1.
Install grease filters. See the "Cleaning" section.
2. Check operation of the Hood Insert blower and lights.
See the "Control" section.
3. If the hood insert does not operate, check to see whether
a circuit breaker has tripped or a houshold fuse has blown.
Disconnect power supply and check that the wiring is correct.
NOTE: To get the most efficient use from your new hood
insert, read the "Control" section.
DESCRIPTION OF THE HOOD
2
1
1.
Blower and light controls
2.
LED lamps
CONTROL
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
hood before cooking and allow it to operate several minutes
after the cooking is complete to clear all smoke and odors
from the kitchen.
The hood controls are located on the center side of the range
hood.
Recessing Knobs
You can hide control knobs by depressing them until flush
with the hood body.
Pressing the knobs again will lower the knobs, and enable
the user to operate the lights and blower.
4
3
3.
Grease filter handle
4.
Grease filter
Controls
A
A. Lamps knob
B. Blower knob
Operating the lamps
1.
Turn the light switch to the "ON" position to turn the
range hood lights On.
2. Turn the light switch to the "OFF" position to turn the
range hood lights Off.
Operating the blower
1.
Turn the blower switch at "1" to turn the range hood on.
2. Turn the blower switch to the desired speed position.
3. Turn the blower switch to the "MAX" position to turn the
range hood on High.
4. Turn the blower switch to the "OFF" position to turn the
range hood blower Off.
Auto On blower
The range hood is equipped with a sensor to automatically
turn on the blower when excessive heat is detected in the
control area. When the blower switch is in the "Off" position,
this sensor will turn the blower to high speed when necessary.
When the heat decreases, the blower will turn off. When the
blower switch is in the On position, the heat sensor is not
active and the range hood functions normally.
B
9

Publicidad

loading

Este manual también es adecuado para:

Esc146ss