Publicidad
Idiomas disponibles
Idiomas disponibles
English
*
ALWAYS READ
INSTRUCTION
BEFORE USE
18
WARNING: Keep these instructions with the product and fill in the identification sheet, entering the information
taken from the markings.
WARNING:
The periodic examination is essential to test the resistance and condition of the equipment and to
guarantee the safety of the user.
WARNING:
Read all safety warnings,
instructions, illustrations and specifications
provided with this product. Failure to follow all
instructions listed below may result in serious injury.
•
A Competent person must examine this
equipment at least once each year in strict
compliance with the instructions of the
manufacturer and the previous check must be
recorded on the attached sheet.
•
The frequency of inspection should be increased
in accordance with the regulations, if the
equipment is in heavy usage or if the equipment
is used in harsh environments. Also ensure that
the markings are legible.
The SRL should be inspected prior to each use as per the
following guidelines:
a ) Do not use if any part of the device appears to be
damaged.
b ) Do not attempt to service the device or alter it in
any way.
DEWALT
c )
SRL's should be used only with the
combinations of components, sub-systems
or both which may affect or interfere with
the safe function of one another. Be certain
that connecting devices are compatible and
that other elements of the PFAS are safe and
compatible before use.
d ) Always check for obstructions below the work
area to make sure that the potential fall path is
clear.
e ) Keep the equipment away from anything that
could damage it such as sharp edges, rough or
abrasive surfaces, high temperature surfaces,
heat and welding sources, moving machinery,
electrical hazards, etc.
f ) It is important to keep in mind environmental
hazards when selecting fall protection
equipment.
g ) Do not expose the equipment to chemicals,
highly corrosive or caustic environments, or to
direct sunlight and UV radiation, which may
cause UV degradation.
English
h ) Such harmful environments require a more
frequent inspection and servicing program of
the fall protection equipment to maintain the
integrity and safety of the equipment. Contact
DEWALT if in doubt.
i ) All the synthetic material of fall protection
equipment must be protected from slag, hot
sparks, open flames or other heat sources.
j ) It is recommended that heat resistant materials
are used in such applications. It is important to
allow adequate fall clearance below the work
surface.
k ) Always have a Rescue Plan ready and at hand
when using this equipment.
SYSTEM REQUIREMENTS:
DEWALT
•
Compatibility of Components:
Protection equipment is designed to be used
DEWALT
with
approved components. Please
contact
DEWALT
if you have a question regarding
compatibility. Making substitutions without
DEWALT
approval from
Fall Protection may lead
to injuries and or death by compromising the
safety and reliability of the complete system.
A Qualified person can make a determination
on compatibility of equipment from different
manufacturers.
•
Compatibility of Connectors: Connectors
(D-rings, hooks, carabiners) must be capable
of supporting at least 5000 lbs. (23 kN). Do not
use equipment that is not compatible. Non-
compatible connectors may unintentionally
disengage. Self-locking snap hooks and
Carabiners are required by CSA, ANSI and OSHA.
Connectors must be compatible in size, shape,
and strength.
•
Making Connections: Only use self-locking
DEWALT
snap hooks and carabiners with any
Protection equipment. Do not use equipment
that is not compatible.
Fall
Fall
19
Publicidad
