Flex FX4321 Manual Del Operador página 14

WARNING
product damage due to a short circuit, never
immerse your charger or battery pack in
fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
WARNING
Intended use: The tool is intended for driving nails into wooden workpieces.
This straight nailer must be used only with the battery packs and chargers listed below:
2.5Ah 3.5Ah
FX0111 FX0321 FX0121 FX0331 FX0221 FX0341
NOTE: Please refer to the battery pack and charger manuals for detailed operating
information.
DEPTH OF DRIVE ADJUSTMENT (FIG. 6)
It is advisable to test the depth of drive on a
scrap workpiece to determine the required
depth for the application.
Harder materials and longer nails will require
more force to drive the nail.
WARNING
others when making adjustments. Failure to
do so may cause serious injury.
a. Remove the battery pack from the tool.
b. Turn the depth selector up or down to adjust
the depth as indicated by the depth arrow.
c. Reattach the battery pack and restart the tool
by pressing and holding the power switch for
1 second.
d. Drive a test nail after each adjustment until
the desired depth is set.
NOTE: If the air pressure in the cylinder is too
low, the nails won't be driven into the wood
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
If any parts are damaged
or missing, do not operate
To prevent accidental
starting that could cause
Battery Pack
5.0Ah 6Ah 8.0Ah
Always point the nailer
away from yourself and
serious personal injury, always remove the
battery pack from the tool when assembling
or adjusting parts.
WARNING
does not fit all operators in the same way. Make
sure the eye protection chosen has side shields
or provides protection from flying debris both
from the front and sides.
The tool is not suitable for fixing electric cables.
WARNING
It is not designed for electric cable installation
and may damage the insulation of electric
cables thereby causing electric shock or fire
hazards.
10Ah 12Ah
FLEX
FX0231
FX0411
Fig. 6
properly. Follow operator's manual included with
FLEX cordless nailer air refill kit model FT433
(sold separately) to restore the air pressure in
the cylinder.
-14-
Always wear eye
protection. Eye protection
Do not use this nailer for
fastening electrical cables.
Charger
FLEX FLEX
FX0421 FX0431
Depth Selector
Shallower
Deeper
FLEX
FX0451