Flex FX4321 Manual Del Operador página 15

DRIVING NAILS (FIG. 7)
WARNING
mechanism during operation of the tool.
Doing so could result in possible serious injury.
NOTE: If no other action is taken after the
power switch is pressed, the nailer will turn off
automatically after 30 minutes.
Single Sequential Actuation Mode:
Single sequential actuation provides the most
accurate nail placement.
a. Make sure the workpiece is secured before
performing any operation.
b. Attach the battery pack and start the tool by
pressing and holding the power switch for 1
second.
c. Briefly press the mode select button to select
the single sequential actuation mode "
d. Grip the tool firmly to maintain control.
Position the workpiece contact of the tool onto
the work surface.
e. Push the tool against the work surface to
depress the workpiece contact. Then squeeze
the trigger switch to drive a nail.
f. Release the trigger switch and lift the nose
from the workpiece to complete the nailing
action.
g. Repeat the steps "d" through "f" to drive more
nails.
NOTE:
Hold the trigger squeezed until drive cycle is
•
complete.
If there is no more action for more than 10
•
seconds after workpiece contact pressed
without releasing, firing will be locked until
the user releases both workpiece contact and
trigger switch and restarts the operation (step
'e').
Contact Actuation Mode:
Contact actuation allows very fast repetitive nail
placement.
a. Make sure the workpiece is secured before
performing any operation.
b. Attach the battery pack and start the tool by
pressing and holding the power switch for 1
second.
c. Briefly press the mode select button to select
the contact actuation mode "
Never wedge or hold back
the workpiece contact
".
Fig. 7
Workpiece Contact
d. Grip the tool firmly to maintain control.
".
e. Squeeze and hold the trigger switch.
f. Push the tool against the work surface to
depress the workpiece contact and drive a
nail. Keep the trigger squeezed.
g. Relocate the tool to the next nailing spot
and push the tool against workpiece to drive
another nail.
h. Release the trigger when done.
NOTE:
Contact actuation mode still retains the logic
•
of the single sequential actuation mode.
This means the tool can also be operated by
depressing the workpiece contact against the
surface and squeezing the trigger switch.
If there is no more action for more than 10
•
seconds after workpiece contact or trigger
switch pressed without releasing, firing will be
locked until the user releases both workpiece
contact and trigger switch and restarts the
operation (step 'e').
When the magazine has 8-10 nails remaining,
the dry-fire lockout feature will not allow
continued operation. To resume operation,
reload the tool with nails.
-15-
Trigger
Switch
Mode Select
Button
DRY-FIRE LOCKOUT
Power
Switch