PRESIDENT BILL Manual Del Usuario página 45

2. Use s/t (3) on the unit or UP/DN (3) on the microphone
to select the RG-BP menu.
3. Press the F (5) key to confirm. The actual value blinks.
4. Use s/t (3) on the unit or UP/DN (3) on the microphone
to change the value of the ROGER BEEP, On/Of (default).
5. Press again the F (5) key to confirm. Start again at point
2 to set another menu or...
6. Press the PTT switch (11) to confirm and exit the
mode. disappears on the display.
7. If no key is pressed, the unit exits the
10 seconds.
disappears on the display.
When the function is activated, "
display.
4) EMG SETTING
Priority channels can be set to any channel in AM or FM
mode. To set a new emergency channel:
MENU
1. Enter into the mode (see § MENU MODE, point 1
page 43)
2. Use s/t (3) on the unit or UP/DN (3) on the microphone
to select the EMG-ST menu.
3. Press the F (5) key to confirm. The first parameter (1 or 2)
blinks.
4. Use s/t (3) on the unit or UP/DN (3) on the microphone
to set the emergency channel 1 or 2.
5. Press again the F (5) key to confirm. The second parameter
(the channel) blinks.
6. Use s/t (3) on the unit or UP/DN (3) on the microphone
to set the channel.
7. Press the F (5) button to validate the selected channel.
8. Use s/t (3) on the unit or UP/DN (3) on the microphone
9. Press again the F (5) key to validate the Mode selection.
10. Press the PTT switch (11) to confirm and exit the
MENU
MENU
mode after
11. If no key is pressed, the unit exits the
" appears on the
5) MIC TYPE
1. Enter into the
2. Use s/t (3) on the unit or UP/DN (3) on the microphone
3. Press the F (5) key to confirm. The actual value blinks.
4. Use s/t (3) on the unit or UP/DN (3) on the microphone
5. Press again the F (5) key to confirm. Start again at point
6. Press the PTT switch (11) to confirm and exit the
45
The third parameter (mode) blinks.
to select AM or FM mode.
Start again at point 2 to set another function or...
mode. disappears on the display.
10 seconds.
disappears on the display.
The default emergency channels are channel 9 / AM
(EMG1) and channel 19 / AM (EMG2) respectively.
The PRESIDENT BILL can be used with either an electret
or dynamic 6-pin PRESIDENT microphone (see wiring the
microphone page 69).
The Mic type can be defined as follows:
MENU
mode (see § MENU MODE, point 1
page 43)
to select the MIC-TP menu.
to change the type, EL (electret) / Dy (dynamic).
2 to set another menu or...
mode. disappears on the display.
MENU
MENU
mode after
MENU