Functions Turning On The Unit; Menu Mode - PRESIDENT BILL Manual Del Usuario

9) USB CHARGING SOCKET
The USB socket (9) can be used to charge a smartphone,
tablet or other rechargeable device with 5 V - 2.1 A.
10) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver
and makes the setting of the equipment into the dash-
board easier. The BILL ASC accepts electret or dynamic
microphone (see menu MIC TYPE on page 45).
See cabling diagram page 69.
11) PTT (Push To Talk)
Transmission key, press PTT switch to transmit a message,
is displayed and release to listen to an incoming
communication.
TOT (Time Out Timer)
If the PTT switch (11) key is pressed for more than 3 minutes,
the display starts blinking and the transmission ends.
A beep will sound until the PTT switch (11) key is released.
C) FUNCTIONS TURNING ON THE UNIT
2 additional functions are available. FREQUENCY BAND
SELECTION, F key (5) and the MENU mode, AM/FM key
(7).
To activate a function, first turn off the unit. Then turn on
the radio while pressing the corresponding key (5) or (7).
1) F -
FREQUENCY BAND SELECTION
(Configuration: EU; PL; d; EC; U; In)
1. Turn on the power while pressing the F key (5). The letter
2. In order to change the configuration, use the s/t keys
3. When the configuration is selected, press the F key (5) 1
4. At this point, confirm the selection by switching off the

2) MENU MODE

1. Turn on the radio while pressing the AM/FM key (7) to
2. Use s/t (3) on the unit or UP/DN (3) on the microphone
3. Press the F (5) key to confirm the chosen menu. The
4. Use s/t (3) on the unit or UP/DN (3) on the microphone
5. Press again the F (5) key to confirm the value of the chosen
(F key)
43
The frequency bands have to be chosen according to the
country of use. Don't use any other configuration. Some
countries need a user's licence. See table page 71.
corresponding to the current configuration is blinking.
(3) on the unit or the UP/DN key (3) on the microphone.
second. The letter corresponding to the configuration is
continuously displayed and a confirmation beep sounds.
transceiver and then switching it on again.
See the frequency bands table at pages 66 to 68 /
configuration table page 70.
(AM/FM key)
MENU
enter into the mode.
The order of the 6 menus is the one described in this
manual. However, the menu displayed when entering
MENU
the mode will be the last menu edited by the
user.
Whatever the menu, the procedure is the same:
to select the menu to be set.
parameter of the menu blinks in the display.
to select the parameter value.
parameter. The parameter stops blinking and, if the function
has more than one parameter, then the next parameter
blinks. Start again at point 2 to set another menu or...
appears.