Inverter Status; Display Information - Aros APPENDIX 1500 Manual De Instrucciones

10 Inverter status

The PV-inverter is designed to be user-friendly; therefore, the status of the inverter can
be easily interpreted by reading the information shown on the front panel display. The
various display panel information is shown in the following table. (See "Table 1" in
appendix)

10.1 Display information

Operating
conditions
Power off
Standby
Initialization &
waiting
Check grid
Supplying grid,
MPPT
FLASH
Instantaneous output
power
Supplied energy
information
Grid voltage
Grid frequency
Supplied current
PV array voltage
Page 30
- ENGLISH -
Message in
English
Normal working status
No display
Standby
Waiting
Checking
Normal State
FLASH
Monitoring parameters
Pac=xxxxW
Energy=xxxxxxkWh
Vac=xxx.xV
Frequency=xx.xHz
AC Current=xx.xA
Vdc=xxx.xV
System fault
Description
PV inverter is totally shutdown, voltage
below "Working range"
Input voltage below "Working range" and
above "Shutdown voltage"
The input voltage is within the "Working
range" but below "Initial feed in voltage"
during start-up. Once the PV voltage is
higher than "Initial feed In voltage", the
inverter will wait to supply the grid
When the PV voltage is greater than "Initial
feed in voltage", the inverter will check the
grid conditions
The inverter is supplying power. After 10
seconds of this message, the LCD will show
the supplied wattage.
FLASH firmware
The real time output power in xxxx W
The total energy that has been supplied to
the grid since the inverter was installed
Grid voltage in xxx.x V
Grid frequency in xx.x Hz
Supplied current in xx.x A
Input voltage from the PV array, xxx.x V
AC
DC